4520 - KB3IAI_UHF
Timeframes are in UTC
| Owner | Chris Mishaga |
| QTH Locator | FM19pb |
| Coordinates(lat, lon) | 39.048°, -76.697° |
| Altitude | 30 m |
| Min Horizon | 10° |
| Target Utilization | 100 % |
| Antennas | Quadrafilar (UHF) |
| Success Rate |
|
| Observations | 585 |
| Creation Date | 1 month, 3 weeks ago |
| Client version | 2.1.1 |
| Online | Last seen 0 minutes ago |
| Uptime | 2 days, 19 hours |
Raspberry Pi 5 with RTL-SDR v4 connected to "3D Printed UHF QFH Antenna by surligas" (See Satnogs wiki) with Minicircuits 400-510 bandpass filter on the front end before the pre-amp, Uptronics 440 Mhz CubeSat filtered pre-amp (427 - 450 Mhz with >=16dB gain) The QFH antenna's need about 15-20 degrees elevation. Pre-amp scripted in satnogs-config to switch on/off automatically. Currently, due to position of antenna, near overhead or westerly passes are best heard by this station.
| Status | Datetime | Time since Change |
|---|---|---|
| Online | 2026-01-25 12:59:30 | 2 days, 19 hours ago |
| Offline | 2026-01-20 07:33:20 | 1 week, 1 day ago |
| Online | 2026-01-14 16:33:31 | 1 week, 6 days ago |
| Offline | 2026-01-14 16:33:20 | 1 week, 6 days ago |
| Online | 2025-12-21 10:50:47 | 1 month ago |
| Offline | 2025-12-21 02:33:20 | 1 month, 1 week ago |
| Online | 2025-12-03 03:57:41 | 1 month, 3 weeks ago |
| Testing | 2025-12-03 03:39:46 | 1 month, 3 weeks ago |
| Online | 2025-12-03 03:29:14 | 1 month, 3 weeks ago |
| Offline | 2025-12-03 03:10:45 | 1 month, 3 weeks ago |